Site Loader

Dgb Board Layout No options Displays processor information. Copies of documents which have an ordering number and are referenced in this document, or other Intel literature, may be obtained from: Standby Current Requirements Bus Initialization Checkpoints Page of 88 Go. The computer starts the Setup program.

Uploader: Faunris
Date Added: 9 April 2016
File Size: 15.77 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 51040
Price: Free* [*Free Regsitration Required]

Instantly Available Technology Technical Reference Table Cd-rom Legacy Style Connector j2d2 This menu reports processor and memory information and is for configuring the system date and system time.

Auxiliary Line In Connector j2c1 Processor Voltage Regulator Fan Connector j3m1 Mic In Connector optional Online Support Custom splash screens http: Don’t have an account?

Got it, continue to print. Installation Instructions Appropriate protection is provided by a maximum 8-A current limiting circuit or a maximum 5-A fuse or positive temperature coefficient PTC resistor. Location Of Standby Power Indicator Go to the Intel World Wide Web site: Place the board component side up on a flat, supportive surface, preferably on the anti-static bag itel which the board was shipped in.

  DILONG JOYPAD DRIVER

Installing a Memory Module To install the memory modules, follow these steps: Port 80h Post Codes Power Supply Considerations Figure 19 shows the correct installation of the cable.

Diagnostic Led Codes NVRAM is being checked to see if it is valid.

Setting The Bios Infel Jumper Installing A Processor Table of Contents Add to my manuals Add. Figure 14 illustrates the mechanical form factor for the DGB board.

Removing A Processor Atapi Cd-rom Connector j2d1 Fan Control And Monitoring Main Power Connector j10k1 Custom splash screens http: Replacing The Battery Localized High Temperature Zones Replace the computer cover, connect the power cord, turn on the computer, and allow it to boot. Always turn off the power and unplug the power cord from the computer before changing a jumper setting.

You will be asked to reboot the system when the update process is complete. Download the file to your hard drive.